ຮັບສ່ວນຫຼຸດພິເສດຕາມປະລິມານ, ອັບເດດລາຄາຂາຍສົ່ງ ແລະ ການແຈ້ງເຕືອນສິນຄ້າໃໝ່ສົ່ງກົງເຖິງອິນບັອກຂອງທ່ານ.
ໂດຍການສະໝັກສະມາຊິກ, ທ່ານຍອມຮັບ ເງື່ອນໄຂການໃຫ້ບໍລິການ ແລະ ນະໂຍບາຍຄວາມເປັນສ່ວນຕົວ ຂອງພວກເຮົາ.
ເຂົ້າເຖິງຜູ້ຊ່ຽວຊານທີ່ໄດ້ຮັບການຢັ້ງຢືນຂອງພວກເຮົາໂດຍກົງ
PP simulation: Open NC, 13A , 20A, 32A, 63A - selection via rotary switch
CP status: A, B, C, D
CP/PE error: 3 buttons on side for error simulation; CP/PE or diode short-circuit and opening of PE
Earth fault PE error: PP switch position NC
Protection / Admissible overload: 600 Vrms
Outputs
L1/L2/L3/N and PE measurement terminals: 230 V single-phase and 400 V three-phase 50 Hz, 5 sockets with 4 mm diameter for connection of the installation tester,
equipped with banana plugs
SCHUKO-type mains socket (earth provided by the 2 studs on the inner edges): Max 250 V, CAT II 300 V, admissible current 10 A (fuse)
CP signal terminal: PWM +/-12V communication protocol
Specifications
Input voltage: 230 V/400 V AC 50/60 Hz 10 A
EVC-20 charging-station socket connector with protective cover: Charging mode 3 adapted to IEC 62196-2 type 2 socket or fixed cable with connector for type 2 vehicle, three-phase
Power socket protection: Fuse T 10 A/250 V
General Specifications
LEDs: X3 - blue
Electric vehicle standards - Installation: IEC 61851-1 / IEC 60364-7-722
Safety: EN 61010-1, pollution degree 2, CAT II 300V
IP: IP 20 as per IEC 60529
Connection socket: Type 2 32 A 3PH+N+PE type E2201 200/346 V
Dimensions / weight: Casing dimensions 150x83x77 mm / Weight: 850 g
Option: CA.6117
