ຮັບສ່ວນຫຼຸດພິເສດຕາມປະລິມານ, ອັບເດດລາຄາຂາຍສົ່ງ ແລະ ການແຈ້ງເຕືອນສິນຄ້າໃໝ່ສົ່ງກົງເຖິງອິນບັອກຂອງທ່ານ.
ໂດຍການສະໝັກສະມາຊິກ, ທ່ານຍອມຮັບ ເງື່ອນໄຂການໃຫ້ບໍລິການ ແລະ ນະໂຍບາຍຄວາມເປັນສ່ວນຕົວ ຂອງພວກເຮົາ.
ເຂົ້າເຖິງຜູ້ຊ່ຽວຊານທີ່ໄດ້ຮັບການຢັ້ງຢືນຂອງພວກເຮົາໂດຍກົງ
Max Capacity: 50.00N / 5.000 kgf / 5000gf / 11.02lbf
Resolution: 0.01N / 0.001kgf / 1gf / 0.01lbf
Unit: kgf, gf, lbf, N
Accuracy: 0.2 %of F.S
Repeatability: 0.1% of F.S
Response: Variable, 10 to 32 Hz
Display: 4 Digit LCD
A/D Converter: 16 Bits
Calculation Device: 8 Bit CPU C-MOS Type
Allowable Load: 150%of F.S.
Data Output: Mitutoyo, Centronics, RS-232C ( Optional items required if non-Mitutoyo devices are used ).
Analogue Output: +/- 2V F.S
Continuous Operation Time: Approx. 10 hrs ( 25 degree C when fully charged )
Charging Time: Approx. 6 hrs ( Circuit preventing over-charging is built-in )
Operating Temperature: 0 to 40 degree C
Power: Ni-cad Battery, Feeder
CHARACTERISTICS
HF SERIES
The HF series is used not only for load measurements but also for a variety of tests including switch test. Connector’s insertion/ withdrawal test and break-down test. In addition, low-cost centronics interface which enables printing of measured data and statistical data through portable printer is also available.
Features
• High resolution
1/10000 resolution (1kgf, 10kgf, 100kgf type) which is not found in common hand held models.
• Memory function. Battery backup
Can memorize 512 unit testing data at most.
• Printing of inspection report
Inspection report can be printed in portable printer through Centronics Interface.
• Statistical processing
Automatic calculation and printing of standard deviation and process capability index.
• Insertion withdrawal measurement
Peak data under compression and peak data under tension can be done in one measurement.
• Mode setting
The HF series function not only act as a force gauge but is also designed to perform a variety of other measurements. In performing other measurements, mode setting enhances measurement efficiency.
• High functionality
Unit Change: gf, kgf, N ,lbf.
Measurement is possible during contact point hold (for switches normally open or normally close).
Digimatic output.
RS-232C (Cable is optional)
Analog output (2V F.S)
Auto memory with auto reset
comparator with upper and lower limit tolerance setting.
Peak hold with Break-Down detection.
continous operation by monitored charging function.
More than 8 hours of battery life.
Auto power OFF that is energy saving.
Overload alarm output.
