ຮັບສ່ວນຫຼຸດພິເສດຕາມປະລິມານ, ອັບເດດລາຄາຂາຍສົ່ງ ແລະ ການແຈ້ງເຕືອນສິນຄ້າໃໝ່ສົ່ງກົງເຖິງອິນບັອກຂອງທ່ານ.
ໂດຍການສະໝັກສະມາຊິກ, ທ່ານຍອມຮັບ ເງື່ອນໄຂການໃຫ້ບໍລິການ ແລະ ນະໂຍບາຍຄວາມເປັນສ່ວນຕົວ ຂອງພວກເຮົາ.
ເຂົ້າເຖິງຜູ້ຊ່ຽວຊານທີ່ໄດ້ຮັບການຢັ້ງຢືນຂອງພວກເຮົາໂດຍກົງ
Bowl dimension: Ø35*Ø25*10mm (bowl mouth*bowl bottom*H)
Nozzle: Ø2mm, 60° inclination with the bowl, 50mm below the
lowest edge of the appliance
Lift travel: 1m
Pressure: 0.4Mpa, meter display
Test time: 5min (manual control)
The splash test apparatus meets the requirements of IEC60335-2-75 clause 15.1.1 and figure 101, IEC60335-2-64 clause 15.1.1 and 15.1.2, GB4706.38 and GB4706.52. It’s used for the splash test of the appliance of the professional type classified IPX1, IPX2, IPX3 and IPX4. The whole device is made of aluminum sheet, and can move freely with wheels. The nozzle, bowl and hose are made of stainless steel, and equip with pressure gauge to real time to display the water pressure.
The water pressure is so regulated that water splashed up 150mm above the bottom of the bowl. The bowl is placed on the floor for appliances normally used on the floor. For all other appliances, on a horizontal support 50mm below the lowest edge of the appliance, the bowl is so moved around as to splash the appliance from all directions. Care is taken that the appliance is not hit by the direct jet. The splash test lasts for 5min.
