Multifunctional moisture gauges measure humidity on most materials.
Measuring range: 0-35%
Designed for flat, curved, smooth or rough surfaces such as hats or beams, rolls or stacks or cartons.
Can be used on almost all non-metallic materials
The electrode is 3 "(7.6 mm) in area.
Back: 3/4 "(1.9 cm).
Handset, rechargeable battery
Method of measurement: Radio frequency
Power supply: 220VAC
Model A8: All-Purpose Moisture Meter
The Model A8 is similar to the T8, except that it has stainless steel buttons on the electrode.
Designed for flat, curved, smooth, or rough surfaces such as cones or beams of yarn, rolls or stacks of cloth, rolls or stacks of paper or paperboard, carpets, tiles, etc.
The electrode covers a 3 inch diameter area and the penetration is about ¾ of an inch. Complete with Rechargeable Battery, Carrying Case and Operating Instructions Book.
Option 115 VAC for North America, South America, Japan
Option 220 VAC for Australia, Europe and most of Asia
Designed for all-purpose use and powered by a NiMh battery that can be quickly re-charged, the Model A8 All-Purpose Moisture Meter permits nondestructive tests for moisture content on most flat, curved, solid or semi-solid materials.
The A8 is ruggedly constructed, easy-to-use instrument with intergrated solid-state circuitry for reliability and long battery life. Its light weight design includes a molded handle with a spring-loaded switch bar that permits testing with either hand.
Finna Group’s patented electrode designs project an RF field into the sample. The RF signal loss due to the presence of moisture is measured and displayed directly as “Moisture Content Percentage”.
The A8 is equipped with four sensitivity settings to provide moisture measurement in the range of 0-35% on most materials. The Zero Suppression feature provides scale overlap in all ranges from 0% to high moisture content
Built-in electrical standards for each range allows for calibration checks at any time by turning a switch, and a built-in adjustment trimmer for each range permits calibration to be reset if necessary. A battery regulator circuit provides constant calibration as the battery discharges.
Designed for flat, curved, smooth, or rough surfaces such as cones or beams of yarn, rolls or stacks of paper or paperboard.
Can be used on nearly all non-metallic materials
The electrode covers a 3″ diameter (7.6 mm) area.
Electrode Penetration: 3/4″ (1.9 cm).
Sample calibration curves available for a wide range of materials.
Pin Feature: Pinless
Measurement Method: Radio Frequency
Voltage: 115 VAC, 220 VAC, analog