Get exclusive volume discounts, bulk pricing updates, and new product alerts delivered directly to your inbox.
By subscribing, you agree to our Terms of Service and Privacy Policy.
Direct access to our certified experts
Get exclusive volume discounts, bulk pricing updates, and new product alerts delivered directly to your inbox.
By subscribing, you agree to our Terms of Service and Privacy Policy.
Direct access to our certified experts

Max Capacity: 20.00N / 2.000 kgf / 2000gf / 4.408lbf
Resolution: 0.01N / 0.001kgf / 1gf / 0.001lbf
Unit: kgf, gf, lbf, N
Accuracy: 0.2% of F.S
Repeatability: 0.1% of F.S
Response: Variable, 10 to 32 Hz
Display: 4 Digit LCD
A/D Converter: 16 Bits
Calculation Device: 8 Bit CPU C-MOS Type
Allowable Load: 150% of F.S.
Data Output: Mitutoyo, Centronics, RS-232C ( Optional items required if non-Mitutoyo devices are used ).
Analogue Output: +/- 2V F.S
Continuous Operation Time: Approx. 10 hrs ( 25 degree C when fully charged )
Charging Time: Approx. 6 hrs ( Circuit preventing over-charging is built-in )
Operating Temperature: 0 to 40 degree C
Power: Ni-cad Battery, Feeder
CHARACTERISTICS
HF SERIES
The HF series is used not only for load measurements but also for a variety of tests including switch test. Connector’s insertion/ withdrawal test and break-down test. In addition, low-cost centronics interface which enables printing of measured data and statistical data through portable printer is also available.
Features
• High resolution
1/10000 resolution (1kgf, 10kgf, 100kgf type) which is not found in common hand held models.
• Memory function. Battery backup
Can memorize 512 unit testing data at most.
• Printing of inspection report
Inspection report can be printed in portable printer through Centronics Interface.
• Statistical processing
Automatic calculation and printing of standard deviation and process capability index.
• Insertion withdrawal measurement
Peak data under compression and peak data under tension can be done in one measurement.
• Mode setting
The HF series function not only act as a force gauge but is also designed to perform a variety of other measurements. In performing other measurements, mode setting enhances measurement efficiency.
• High functionality
Unit Change: gf, kgf, N ,lbf.
Measurement is possible during contact point hold (for switches normally open or normally close).
Digimatic output.
RS-232C (Cable is optional)
Analog output (2V F.S)
Auto memory with auto reset
comparator with upper and lower limit tolerance setting.
Peak hold with Break-Down detection.
continous operation by monitored charging function.
More than 8 hours of battery life.
Auto power OFF that is energy saving.
Overload alarm output.



