Thiết bị thử lực lò xo - tải trọng thấp JISC PRO-100N (100N (10kgf))

Tải trọng tối đa: 100N (10kgf)

Chuyển đổi tự động dải cao/thấp: 100N / 10N

Độ phân giải lực: 0.01N / 0.001N

Độ chính xác lực: Theo tiêu chuẩn JIS B 7738 cấp 0.5 (±0.5% tải trọng tác dụng)

Hành trình tối đa: 200mm

Độ phân giải hành trình:

Mẫu cơ bản & mẫu đặc biệt: 0.01mm

Mẫu cao cấp: 0.001mm

Độ chính xác chiều dài: ± (0.05 + 0.0001 × L) mm (với L là chiều dài đo)

Tốc độ thử nghiệm: 1 ~ 600 mm/phút

Đe tiêu chuẩn (thép): Trên & Dưới Ø60mm

Nguồn điện: 1 pha AC 220~240V (50/60Hz)

Công suất tiêu thụ: 100 VA

Kích thước: Rộng 450 × Dài 400 × Cao 530 mm

Trọng lượng: Xấp xỉ 60 kg

• The whole series meets 05 grade (Highest Grade) of JIS B 7738 Coil spring compression / tension tester.

• In addition to 1 -step , 2 -step, 3 -step automatic tests, free length, initial tension load, solid length, max, load (peak hold) can also be measured.

• Unit select able among N, gf, kgf, lbf and inch covered by English version.

• Measurement range can be changed through 2- step high-low range automatic switch over function, there by eliminating unnecessary steps.

• Dual unit (gf, kgf and N) printing is possible through printer setting. 50 Tests conditon can be stored by registering model number.

• Test can start immediately once data are read.

• Passing range or Good / Bad assessment is done visually by using screen display and alarm.

• Can be connected to digital caliper, micrometer etc.. And data can be printed out.

• Ascend and descend buttons are equipped with inching function.

• Simple movements of 1mm, 0.1mm, (0.001mm) are possible.

“Load test with length input”, load is measured automatically once length is input. (All-Type)

”Length test with Load input”, spring length is measured automatically once load is input. (S-Type, H-Type)

”Deflection load test”, load is measured automatically based on deflection amount resulted from free length. (S-Type, H-Type)

”Load deflection test”, deflection amount corresponding to applied load resulted from free length is measured automatically.

”Step load test”, load is measured as length is step automatically fixed intervals. (H-Type)

”Step length test”, length is measured as load is step automatically fixed intervals. (H-Type)

Datasheet