emin

Dillon XC 힘 게이지 (50kg)

  • 생산업체: DILLON
    Model: X-C force gauge (50kg)
    • 견적요구 견적요구
  • 연락처
  •  할인 받으려면 전화하십시오

    핫라인: (+84) 969950220

    전화번호+84 (24) 62923267

  • 품질 보증
  • 공인 보증
  • 집으로 배달
  • 간단하게 거래하기

Model: X-C force gauge (50kg)   
Manufacture: Dillon
Origin: U.S.A
Warranty: 12 months

Capacity: 50kg
Resolution 5kg
Accuracy: ±1%
Overloads: up to 30% of capacity
 temperature :Operating temperature up to 120° F.
 

세부사항

download datasheet

Principle of operation
A D-shaped deflection beam is the
heart of the Dillon Force Gauge.
Machined to close tolerances, beams
are heat treated to develop optimum
strength and spring characteristics.
High-strength aluminum is used in
Model X instruments through 500
lb (200 kg). Ranges above this are
fabricated from aircraft-quality
alloy steel.
A precision dial indicator is mounted
at the null point of the deflection
beam. The indicator plunger rests
against a slanted anvil at the open
end of the beam, as shown in the
photo. Under compression loads,
the two halves of the beam tend to
close. Tension force causes them to
move apart. This action pushes the
plunger inward, as determined by
the slant of the anvil. Readings
produced on the dial are in direct
relation to applied load. The pointer
revolves 360° clockwise under
compression or tension forces.
Push-pull gauges read half scale
(180°) clockwise in compression, and
counterclockwise, 180° from center
zero under tension loads.
Low beam deflection
When measured across the center
of top- and bottom-loading holes,
the approximate beam deflection is
as follows:
50 to 250-lb capacity  0.019"
(25 to 100 kg)
500-lb capacity  0.016"
(200 kg)
1,000-lb capacity  0.018"
(500 kg)
2,000-lb capacity  0.011"
(1000 kg)
5- and 10,000-lb capacity  0.010"
(2 and 5000 kg)
25,000-lb capacity  0.022"
(10,000 kg)
Overload rating
Accidental overloads up to 30% of
capacity can be safely sustained
without injury to the dial indicator
or deflection beam. All capacities
feature a 5:1 design safety factor.
General information
n  To reset zero, loosen knurled
bezel-locking screw and rotate
dial.
n  Dillon Model X Force Gauges may
be mounted horizontally, vertically,
or flat.
n  The baked-enamel finish resists
corrosion and rust.
n  Operating temperature
up to 120° F.

할인과 정보를 받기 위해 등록하기