GOTT GOTT-STEPPER-403A 基本步进动机培训系统

MAIN TECHNICAL PARAMETER

2-PHASE BIPOLAR MICROSTEP DRIVER

FEATURES

• Input voltage 24-40 VDC 

• Switch selectable motor current from 1.3-3.5 amps/phase 

• 15 switch selectable step resolutions both in cemal and binary, up to 51200 steps/rev 

• Mode of operation : Step & Direction, CW & CCW 

• Up to 200KHz step clock rate 

• Optically isolated 5VDC differential input for step, direction, enables.

• Dual H-bridge, inaudible PWM amplifier Pulse width modulated current control chopping at 20KHz 

• Switch selectable idle current reduction 0 or 50% 

• Strong protection including over voltage, over current 

• LED indicating power and fault status 

• Suitable to drive 4 or 8 lead size 11,14,17,23,34

2-PHASE HYBRID STEPPING MOTOR GOTT5641

Step Angle: 1.8°

Step Angle Accuracy: ±5% (full step, no load)

Resistance Accuracy: ±10%

Inductance Accuracy: ±20%

Temperature Rise: 80°C Max. (rated current, 2 phase on)

Ambient Temperature: -20°C ~+50°C

Insulation Resistance: 100M Min., 500VDC

Dielectric Strength: 500VAC for one minute

Shaft Radial Play: 0.02Max. (450 g-load)

Shaft Axial Play: 0.08Max. (450 g-load)

Max. radial force: 75N (20mm from the flange)

Max. axial force: 15N

GENERAL SPECIFICATION

Input power: AC 240V, 50Hz, 1-phase

Leakage protection: Leakage current: 30mA

Output: 24V DC current output 0~10V analogue signal source

Capacity:  <1KVA

Working environment: -10C ~ +40C

EXPERIMENT TOPICS : 

• Principle of a stepping motor 

• Spindle drive control 

• Wiring with controller and driver 

• Position control by configuration pulse number 

• Sequence control 

• Auto Forward Reverses 

• Forward (Right Limit) 

• Reverse (Left Limit) 

• Timer Counter

Manuals :

 (1) All manuals are written in English

 (2) Model Answer 

(3) Teaching Manuals

Detail

Datasheet


DESCRIPTION 

The GOTT Stepper Motor Trainer is a PC based system that is used to teach the principles and operations of stepper motors. Stepper motors are motors which rotate one step when supplied with a pulse. They are readily interfaced to microcomputers and other digital devices. The control signals required are virtually always the same, regardless of motor size. Position and speed control through pulse control system by interface PC, Thus, the facilities provided on the GOTT Stepper Motor Trainer enable students to write programs for a small unit that gives experience which is valid for any application of stepping motors.

FEATURES 

• Industrial stepper motor driver and controller

 • Speed and position control 

• Linear spindle drive 

• Encoder for position checking 

• 4mm socket and plug wiringn động cơ bước công nghiệp


  • 质量承诺
  • 正品保修
  • 送货到家
  • 交易简单化