EMIN & GWInstek at NEPCON 2019

EMIN Support GWInstek at NEPCON 2019 in International Center of exhibition I.C.E 91 Tran Hung Dao, Hanoi, Vietnam

Vietnamese electronics industry has been changing significantly and undoubtedly turning Vietnam into the world's next electronics manufacturing hub with the presence of many international giants. Since a plethora of emerging opportunities is knocking on the market's door, it is vital for electronics manufacturers to tap into and leverage the opportunities by joining NEPCON Vietnam 2019, Vietnam’s only exhibition on SMT, testing technologies, equipment and supporting industries for electronics manufacturing, an all-in-one platform under the theme of "360º Manufacturing Integration." The event will aim at gathering state-of-the-art technologies and solutions from over 200 brands, updating hottest trends via onsite forums and conferences, and serving attendants with complementary business matchmaking programs.

NEPCON Vietnam 2019 Exhibition taking place from 11-13 September 2019 in Hanoi. That is an opportunity for enterprises & barnch to show their products, expand their business networks. This is also the premise for EMIN to reach out to the world. In 2019, EMIN has successfully opened branches in Myanmar & Singapore. Expected branch in Thailand, Malaysia in the near future.

Below are some photos of GWinstek booths at the Exhibition

関連ニュース

2026年08月10日 14時16分08秒

Comparing Shore A and Shore D Hardness: Two Common Hardness Scales Today

Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D

2026年08月10日 11時17分47秒

What causes equipment to restart automatically in the factory, and how can the fault be identified?

Equipment restarts in a factory setting can be attributed to voltage sags, momentary power outages, electrical noise, overheating, or hardware faults. For incidents that last only a few power cycles, a power quality analyzer can capture voltage, current, and waveform data at the exact moment of the reset, thereby helping engineers determine whether the power supply is the cause

2026年08月10日 09時29分47秒

Oscilloscope and Multimeter FAQ for Practical Test Workflows

This FAQ explains basic oscilloscope concepts, key selection factors, the purpose of Bluetooth multimeters, and the practical difference between OW18B and B35T+ models.

2026年08月10日 09時28分50秒

Why Measured Amplitude Is Lower Than the Real Value

An oscilloscope can display a lower amplitude than the true signal when its bandwidth is not high enough. This article explains bandwidth, the 5x rule, and rise time in practical terms.

2026年08月10日 09時27分59秒

Why Measured Amplitude Can Be Lower Than the Real Value

An oscilloscope can display a lower amplitude than expected when its bandwidth is too limited for the signal being measured. This article explains the relationship between bandwidth, rise time, and measurement accuracy.