[EMINxKeysight] International Electronics & Smart Manufacturing Exhibition 2026

EMIN and Keysight sincerely thank you for taking the time to attend the 2026 International Electronics & Smart Manufacturing Exhibition in Dong Anh

As the 2026 International Electronics & Smart Manufacturing Exhibition concludes, EMIN and Keysight would like to extend our sincere thanks to our valued customers, partners, and all attendees who visited our booth. We appreciate you taking the time to experience Keysight’s advanced test and measurement solutions firsthand and to discuss technology trends and implementation challenges in electronics research, development, and manufacturing.

Although the exhibition has ended, our collaboration with you continues. Our team stands ready to provide ongoing support and deliver the measurement solutions best suited to your business's specific needs. We hope your experience at our booth proves valuable to your work and paves the way for fruitful partnerships in the future.

Here are some highlights captured during the event.

Thank you once again, and we look forward to seeing you at upcoming technology events!

関連ニュース

2026年08月24日 10時12分42秒

Dakota CX – Ultrasonic Thickness Gauges for Measuring Through Coatings up to 2 mm

In non-destructive testing (NDT), ultrasonic thickness gauges allow users to determine material wear and corrosion without dismantling components or cutting samples. Dakota NDT has developed the CX and PCX8-DL series with a focus on fast measurements, simple operation, and a range of functions for on-site thickness inspection.

2026年08月21日 11時50分26秒

Which soldering station is suitable for an electrical cabinet maintenance workshop, and how does it differ from a mobile phone repair soldering station?

While both are classified as soldering stations designed to melt solder, a technician repairing wiring inside an electrical cabinet and one working under a microscope on a mobile phone circuit board require vastly different types of equipment. Check out the article below!

2026年08月21日 10時16分40秒

Smoke and a burning smell when first turning on the soldering station is this normal or a cause for concern?

The soldering station had just been unboxed, plugged in, and switched on for the first time. A few seconds later, a thin wisp of smoke rose from the tip, accompanied by a faint acrid smell. Before any soldering could even begin, many users hastily turned the unit off, fearing the equipment was damaged

2026年08月21日 09時17分36秒

How to quickly fix solder that won't melt? What should be done?

The soldering iron is hot, yet even after touching the resistor lead for ten seconds or more, the solder just clumps up instead of flowing smoothly. A novice's first instinct is often to crank up the temperature. While that sometimes works, temperature isn't always the root cause; in many cases, increasing the heat only burns the flux and pads, potentially ruining the component leads in the process

2026年08月21日 08時28分27秒

THÔNG BÁO NGHỈ LỄ QUỐC KHÁNH 2/9/2026

Công ty CP EMIN Việt Nam thông báo lịch nghỉ lễ Quốc Khánh 2/9/2026