EXHIBITION INVITATION: EMA 2019 IN HCMC

EMIN Vietnam would like to invite customers & partners to visit our exhibition booth "Vietnam International Electricity, Industrial - Machinery & Automation 2019 - EMA 2019"

📍EMIN Vietnam booth position: 09-20, Zone B

🏡Venue: Center for Cultural Sport in Tan Binh District. Add: 448 Hoang Van Thu Str., Ward 4, Tan Binh District, HCMC, Vietnam

⏱Time: 09:00 am - 06:00 pm, 4 days 18~21/09/2019

Layout

EMA VIET NAM 2019 is organized with the aim of creating conditions for domestic and foreign exhibitors to introduce new products, equipment and technologies. Besides, it is also an opportunity for exhibitors to seek cooperation opportunities, attract investment, transfer of technology, promote trade promotion, bring more efficiency for production and business activities, contribute positively to the socio-economic development of our country.

At this exhibition, EMIN will bring electrical and electronic measuring and testing equipment, and introduce to customers measurement solutions in the fields of mechanics, manufacturing, environment meter equipment, laboratory equipment & automation equipment, etc. Gives customer a close look about the quality of EMIN products and services.

THANK YOU AND HOPE TO SEE YOU!

関連ニュース

2026年08月10日 14時16分08秒

Comparing Shore A and Shore D Hardness: Two Common Hardness Scales Today

Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D

2026年08月10日 11時17分47秒

What causes equipment to restart automatically in the factory, and how can the fault be identified?

Equipment restarts in a factory setting can be attributed to voltage sags, momentary power outages, electrical noise, overheating, or hardware faults. For incidents that last only a few power cycles, a power quality analyzer can capture voltage, current, and waveform data at the exact moment of the reset, thereby helping engineers determine whether the power supply is the cause

2026年08月10日 09時29分47秒

Oscilloscope and Multimeter FAQ for Practical Test Workflows

This FAQ explains basic oscilloscope concepts, key selection factors, the purpose of Bluetooth multimeters, and the practical difference between OW18B and B35T+ models.

2026年08月10日 09時28分50秒

Why Measured Amplitude Is Lower Than the Real Value

An oscilloscope can display a lower amplitude than the true signal when its bandwidth is not high enough. This article explains bandwidth, the 5x rule, and rise time in practical terms.

2026年08月10日 09時27分59秒

Why Measured Amplitude Can Be Lower Than the Real Value

An oscilloscope can display a lower amplitude than expected when its bandwidth is too limited for the signal being measured. This article explains the relationship between bandwidth, rise time, and measurement accuracy.