LIVE WEBINAR: INSIGHTS INTO WIDE BAND-GAP APPLICATIONS AND MEASUREMENTS PART II

EMIN Viet Nam would like to invite you to join the webinar: "Insights into WIde Band-gap Applications and Measuremants Part II". The event is oganized by Tekt

EMIN Viet Nam would like to invite you to join the webinar: "Insights into WIde Band-gap Applications and Measuremants Part II". The event is oganized by Tektronix.

Date: 17 - Nov - 2021
Time: 11.00AM (GMT+8)

In this session, the presenter Carl Wong - Regional Application Engineer - will talk about the wide bandgap test challenges, measurement techniques, and test equipment needs including the requirements for a scope, probing techniques, and automated test software that can help meet the tough challenges presented by wide bandgap semiconductor devices.

関連ニュース

2026年08月10日 17時23分32秒

Testing Crankshaft Position Sensors With an OWON Oscilloscope

A practical overview of using the OWON VDS2064 PC oscilloscope to examine magnetoelectric crankshaft position sensor waveforms, identify changing signal patterns, and compare correct and reversed terminal connections.

2026年08月10日 17時05分19秒

Testing Hall Camshaft Sensors with an OWON Oscilloscope

A practical overview of connecting an oscilloscope, observing Hall camshaft sensor waveforms, and comparing timing characteristics in automotive diagnostic work.

2026年08月10日 17時04分12秒

CAN Comfort Waveform Testing with OWON Oscilloscopes

A practical overview of observing CAN Comfort signals in Volkswagen PASSAT B7 maintenance, including sleep-state readings and relevant OWON TAO3000 series features.

2026年08月10日 15時42分43秒

Automotive Throttle Sensor Testing with OWON TAO3000

This practical overview explains how the OWON TAO3000 series and TAO3104A can be used to observe dual throttle position sensor signals during automotive testing.

2026年08月10日 14時16分08秒

Comparing Shore A and Shore D Hardness: Two Common Hardness Scales Today

Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D