Master the Basics Workshop 2019

Master the basics of key measurements using oscilloscopes, power supply and spectrum analyzer with Rohde & Schwarz’s half-day Workshop. In this s

Master the basics of key measurements using oscilloscopes, power supply and spectrum analyzer with Rohde & Schwarz’s half-day Workshop. In this session engineers/technicians can learn the key fundamentals and useful tips to effectively measure signals accurately.

⏱Time: 

🚩Hanoi: 
* 24 June, University of Transport and Communications, No.3, Cau Giay Street, Lang Thuong, Dong Da, HN
* 25 June , Fortuna Hotel No. 6B Lang Ha, Ba Dinh, HN

🚩HCMC: 27, 28 June, Ramana Hotel No. 323 Le Van Sy, District 3, HCMC

Timetable

Time
8.30-8.45am	Opening
8.45-9.45am	Master your Oscilloscope Learn about the most critical behavior of the oscilloscope instrument that allow you to improve your troubleshooting skills and capture any waveform you need. In the workshop, you will master the skill to detect, trigger and measure intermittent signal glitches.
9.45am-10.30am	What they did not tell you about Power Supply Power supply mainly provides enough voltage and current to turn on a load, there can be many aspects of power characteristics that can be important to consider when choosing your next most popular lab instrument. In the workshop, you will investigate these parameters and observe them with oscilloscope
10.30-10.45am	Break
10.45-11.45am	Enhancing measurement accuracy on your Spectrum Analyzer Spectrum Analyzer can be tricky to setup if you do not know critical specification that could limit your measurement accuracy. Learn about the setting considerations to optimize your measurement setup. In the workshop, you will observe how different setting can affect your measurement.
11.45am-12.00pm	Q&A
	Gift & Finish

関連ニュース

2026年08月10日 15時39分24秒

Choosing Communication Interfaces for Test Equipment

A practical guide to selecting RS232, GPIB, LAN, USB, or Wi-Fi for test equipment based on connection range, networking needs, computer compatibility, and instrument control requirements.

2026年08月10日 14時16分08秒

Comparing Shore A and Shore D Hardness: Two Common Hardness Scales Today

Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D

2026年08月10日 11時17分47秒

What causes equipment to restart automatically in the factory, and how can the fault be identified?

Equipment restarts in a factory setting can be attributed to voltage sags, momentary power outages, electrical noise, overheating, or hardware faults. For incidents that last only a few power cycles, a power quality analyzer can capture voltage, current, and waveform data at the exact moment of the reset, thereby helping engineers determine whether the power supply is the cause

2026年08月10日 09時29分47秒

Oscilloscope and Multimeter FAQ for Practical Test Workflows

This FAQ explains basic oscilloscope concepts, key selection factors, the purpose of Bluetooth multimeters, and the practical difference between OW18B and B35T+ models.

2026年08月10日 09時28分50秒

Why Measured Amplitude Is Lower Than the Real Value

An oscilloscope can display a lower amplitude than the true signal when its bandwidth is not high enough. This article explains bandwidth, the 5x rule, and rise time in practical terms.

Master the Basics Workshop 2019

Master the basics of key measurements using oscilloscopes, power supply and spectrum analyzer with Rohde &amp; Schwarz’s half-day Workshop. In this s

関連ニュース

Master the basics of key measurements using oscilloscopes, power supply and spectrum analyzer with Rohde & Schwarz’s half-day Workshop. In this s