Unlock your scope's potential, all without leaving your lab!

If you own a Tektronix 4/5/6 Series Oscilloscope, you can receive 50% off on a license to upgrade bandwidth and record length, add a function generator, purchase individual or bundled software...

EMIN - Authorized Distributor of Tektronix is excited to announce a great way to extend the capabilities of your oscilloscopes. If you own a Tektronix 4/5/6 Series Oscilloscope, you can receive 50% off on a license to upgrade bandwidth and record length, add a function generator, purchase individual or bundled software. Unlock your scope's potential, all without leaving your lab!

Here are a few ways you can enhance your scope's performance:

• Increase bandwidth to achieve reliable measurement results at higher frequencies

• Extend record length to see more of the measured signal

• Add an integrated arbitrary function generator as a powerful tool for simulating signals or adding noise to existing signals

• Add Spectrum View for correlating time and frequency domains

• Automate advanced power measurements with POWER PRO software bundle

• Troubleshoot high-speed clock measurements with SERIAL DECODE PRO software bundle

Many options available as an exclusive offer for Tek scope owners. Don't wait - contact EMIN today! Offer ends June 27th.

関連ニュース

2026年08月21日 11時50分26秒

Which soldering station is suitable for an electrical cabinet maintenance workshop, and how does it differ from a mobile phone repair soldering station?

While both are classified as soldering stations designed to melt solder, a technician repairing wiring inside an electrical cabinet and one working under a microscope on a mobile phone circuit board require vastly different types of equipment. Check out the article below!

2026年08月21日 10時16分40秒

Smoke and a burning smell when first turning on the soldering station is this normal or a cause for concern?

The soldering station had just been unboxed, plugged in, and switched on for the first time. A few seconds later, a thin wisp of smoke rose from the tip, accompanied by a faint acrid smell. Before any soldering could even begin, many users hastily turned the unit off, fearing the equipment was damaged

2026年08月21日 09時17分36秒

How to quickly fix solder that won't melt? What should be done?

The soldering iron is hot, yet even after touching the resistor lead for ten seconds or more, the solder just clumps up instead of flowing smoothly. A novice's first instinct is often to crank up the temperature. While that sometimes works, temperature isn't always the root cause; in many cases, increasing the heat only burns the flux and pads, potentially ruining the component leads in the process

2026年08月21日 08時28分27秒

THÔNG BÁO NGHỈ LỄ QUỐC KHÁNH 2/9/2026

Công ty CP EMIN Việt Nam thông báo lịch nghỉ lễ Quốc Khánh 2/9/2026

2026年08月20日 16時20分23秒

Check food and items stored in the cooler, or measure the temperature for a safe campfire

When thermal cameras are mentioned, most users immediately think of electrical cabinets, motors, PLCs, or HVAC systems in industrial facilities. However, the device's core principle observing surface temperature differences invisible to the naked eye can be applied in entirely unexpected places