お得な情報を受け取る
数量割引、まとめ買い価格の更新、新製品情報をメールでお届けします。
登録することで、当社の利用規約およびプライバシーポリシーに同意したものとみなされます。
クイックサポート
認定専門家へ直接アクセス
数量割引、まとめ買い価格の更新、新製品情報をメールでお届けします。
登録することで、当社の利用規約およびプライバシーポリシーに同意したものとみなされます。
認定専門家へ直接アクセス
Control units: Button control+meter
Raise angle from horizontal: 40°±1°
Mass: 5kg
Inclined plane : the
mass slides against an inclined plate so that the maximum deflection of the
hose is 3°
Length of arm: 300mm±5mm
Rotation speed: 10r/min±1r/min
Number of tests: 2500 revolutions+2500 revolutions (1
revolution: 0°-45°-0°)Setting value: 0-999999 (pre-settable)
Counter
Setting value: 0-999999 (pre-settable)
Real value: display the actual number of tests
Number of test station: 1
Number of test station: 1
Dimension: 500mm*800mm*1850mm (W*L*H)
Working power: 220V/50Hz
This apparatus is designed according to IEC60335-2-2 clause 21.103 and figure 102, it is applied to test the current-carry hose of vacuum cleaners resistant to flexing. During the test, the end of the hose is attached to the pivoting arm of the test equipment, the distance between the pivot axis of the arm and the point where the hose enters the rigid part is 300mm±5mm. The arm can be raised from the horizontal position by an angle of 40°±1°, a mass of 5kg is suspended from the other end of the hose. The test is carried out for 2500 revolutions, and then turned the fixed end of the hose through 90°, and the test continued for a further 2500 revolutions, the test is repeated in each of the other two 90° position. If the hose ruptures before 10000 revolutions of the crank, the flexing is terminated. After the test, the hose shall withstand the electric strength test.
