PICO 4425A 4-Channel Standard Kit 診断用オシロスコープ (4CH, 20 MHz)

Channels: 4

Vertical resolution: 12 bits (16 bits in enhanced resolution mode)

DC accuracy: ±1% of full scale (2% on 50mV range)

Sensitivity: 10 mV/div to 40 V/div

Input ranges (full scale): ±50 mV to ±200 V in 12 ranges

Input impedance: 1 MΩ in parallel with 24 pF

Input type: Floating single-ended PicoBNC+ connector

Input coupling: Software selectable AC/DC

Input overvoltage protection: ±250 V (DC + AC peak)

Buffer memory: 250 M samples shared between active channels

Waveform buffer: Up to 10,000 waveforms

Timebase ranges: 5 ns/div to 5000 s/div

Bandwidth: 20 MHz (10 MHz on ±50 mV range)

Maximum sampling rate (single shot)

1 channel in use: 400 MS/s

2 channels in use: 200 MS/s

3 or 4 channels in use: 100 MS/s

TRIGGERS

Source: Any input channel

Basic triggers: Auto, repeat, single, none

Advanced triggers: Rising edge, falling edge, edge with hysteresis, pulse width, runt pulse, dropout, windowed, logic

Maximum pre-trigger delay: Up to 100% of capture length

Maximum post-trigger delay: Up to 4 billion samples

SPECTRUM ANALYZER

Frequency range: DC to 20 MHz

Display modes: Magnitude, peak hold, average

ENVIRONMENTAL

Operating temperature range: 0 °C to 40 °C (15 °C to 30 °C for quoted accuracy)

Operating humidity range: 5% to 80% RH, non-condensing

Storage temperature range: -20 to +60°C

Storage humidity range: 5 to 95% RH, non-condensing

PHYSICAL CHARACTERISTICS

Dimensions: 190 x 160 x 40 mm (approx 7.5 x 6.3 x 1.6 in)

Weight: <900 g (approx 2 lb)

GENERAL

Additional accessories (supplied) USB cable and Safety Guide

PC interface USB 3.0 (USB 2.0 compatible)

Power requirements Powered from USB port

4-Channel Standard Kit

The standard kit is our most popular kit balancing the cost of the kit while providing all the essential functionality needed for effective diagnosis. With the addition of both high and low amps clamps, technicians are equipped for contact and non-intrusive testing of electrical signals. The kit is available in foam ideal for instant access in your existing tool trolley, or a carry case with foam cutouts

Datasheet