お得な情報を受け取る
数量割引、まとめ買い価格の更新、新製品情報をメールでお届けします。
登録することで、当社の利用規約およびプライバシーポリシーに同意したものとみなされます。
クイックサポート
認定専門家へ直接アクセス
数量割引、まとめ買い価格の更新、新製品情報をメールでお届けします。
登録することで、当社の利用規約およびプライバシーポリシーに同意したものとみなされます。
認定専門家へ直接アクセス
Acquisition timing Selectable simultaneous or alternate acquisition
Bandwidth, full 20 GHz
Bandwidth, narrow 10 GHz
Pulse response rise time, full bandwidth 17.5 ps (10% to 90%, calculated)
Pulse response rise time, narrow bandwidth 35.0 ps (10% to 90%, calculated)
Noise, full bandwidth < 1.5 mV RMS typical, < 2.0 mV RMS maximum
Noise, narrow bandwidth < 0.8 mV RMS typical, < 1.1 mV RMS maximum
Noise with averaging 100 µV RMS system limit, typical
Operating input voltage with digital feedback 1 V p-p with ±1 V range (single-valued)
Operating input voltage without digital feedback ±400 mV relative to channel offset (multi-valued)
Sensitivity 1 mV/div to 500 mV/div in 1-2-5 sequence with 0.5% fine increments
Resolution 16 bits, 40 µV/LSB
Accuracy ±2% of full scale ±2 mV over temperature range for stated accuracy (assuming temperature-related calibrations are performed)
Nominal input impedance (50 ± 1) Ω
Input connectors 2.92 mm (K) female, compatible with SMA and PC3.5
TIMEBASE (SEQUENTIAL TIME SAMPLING MODE)
Ranges 5 ps/div to 3.2 ms/div (main, intensified, delayed, or dual delayed)
Delta time interval accuracy For > 200 ps/div: ±0.2% of delta time interval ± 12 ps
For < 200 ps/div: ±5% of delta time interval ± 5 ps
Time interval resolution 64 fs
Channel deskew 1 ps resolution, 100 ns max.
TRIGGERS
Trigger sources All models: external direct, external prescaled, internal direct and internal clock triggers.
PicoScope 9302 and 9321 only: external clock recovery trigger
External direct trigger bandwidth and sensitivity DC to 100 MHz : 100 mV p-p; to 2.5 GHz: 200 mV p-p
External direct trigger jitter 1.8 ps RMS (typ.) or 2.0 ps RMS (max.) + 20 ppm of delay setting
Internal direct trigger bandwidth and sensitivity DC to 10 MHz: 100 mV p-p; to 100 MHz: 400 mV p-p (channels 1 and 2 only)
Internal direct trigger jitter 25 ps RMS (typ.) or 30 ps RMS (max.) + 20 ppm of delay setting (channels 1 and 2 only)
External prescaled trigger bandwidth and
sensitivity 1 to 14 GHz, 200 mV p-p to 2 V p-p 1 to 15 GHz, 200 mV p-p to 2 V p-p
External prescaled trigger jitter 1.8 ps RMS (typ.) or 2.0 ps RMS (max.) + 20 ppm of delay setting
Pattern sync trigger clock frequency 10 MHz to 11.3 GHzPattern sync trigger pattern length 7 to 8 388 607 (223 − 1)
