Global Technology Supply and Demand Connection Point.

**EMIN at Global Technology Supply and Demand Connection Point.** On March 31, 2017, in Hanoi, the Ministry of Science and Technology (MOST) in collaboration

EMIN at Global Technology Supply and Demand Connection Point.

On March 31, 2017, in Hanoi, the Ministry of Science and Technology (MOST) in collaboration with the Ministry of Agriculture and Rural Development (MARD) and Korea's Small and Medium Business Administration (SMBA) opened Global Technology Supply and Demand Connection Point and Vietnam - Korea Technology Exchange Center (VKTEC).

Attending the Opening Ceremony, on the Vietnamese side, there were Deputy Minister of Science and Technology-Tran Van Tung, General Director of Technological Development and Application Agency-Ta Viet Dung, Director of Agricultural Engineering and Post-Harvest Technology Institute-Pham Anh Tuan; Representatives of local ministries, branches, research institutes, universities, Sciences & Technology Advanced Application centers, Technology Transfer Intermediaries, domestic enterprises. On behalf of Korea, there were Minister of Small and Medium Business Administration (SMBA)- Joo Young Sup, Minister of INNOBIZ- Sung Myung Ki. Attending the opening ceremony were representatives of other foreign companies.

Here are some images of EMIN at Global Technology Supply and Demand Connection Point.

관련 뉴스

2026년 08월 21일 11시 50분 26초

Which soldering station is suitable for an electrical cabinet maintenance workshop, and how does it differ from a mobile phone repair soldering station?

While both are classified as soldering stations designed to melt solder, a technician repairing wiring inside an electrical cabinet and one working under a microscope on a mobile phone circuit board require vastly different types of equipment. Check out the article below!

2026년 08월 21일 10시 16분 40초

Smoke and a burning smell when first turning on the soldering station is this normal or a cause for concern?

The soldering station had just been unboxed, plugged in, and switched on for the first time. A few seconds later, a thin wisp of smoke rose from the tip, accompanied by a faint acrid smell. Before any soldering could even begin, many users hastily turned the unit off, fearing the equipment was damaged

2026년 08월 21일 09시 17분 36초

How to quickly fix solder that won't melt? What should be done?

The soldering iron is hot, yet even after touching the resistor lead for ten seconds or more, the solder just clumps up instead of flowing smoothly. A novice's first instinct is often to crank up the temperature. While that sometimes works, temperature isn't always the root cause; in many cases, increasing the heat only burns the flux and pads, potentially ruining the component leads in the process

2026년 08월 21일 08시 28분 27초

THÔNG BÁO NGHỈ LỄ QUỐC KHÁNH 2/9/2026

Công ty CP EMIN Việt Nam thông báo lịch nghỉ lễ Quốc Khánh 2/9/2026

2026년 08월 20일 16시 20분 23초

Check food and items stored in the cooler, or measure the temperature for a safe campfire

When thermal cameras are mentioned, most users immediately think of electrical cabinets, motors, PLCs, or HVAC systems in industrial facilities. However, the device's core principle observing surface temperature differences invisible to the naked eye can be applied in entirely unexpected places