Industrial rubber typically falls within the 40–80 Shore A range, though there is no single standard hardness for all types; components such as gaskets, seals, vibration dampers, and rollers may utilize different hardness levels depending on specific requirements. Temperature also significantly affects measurement results: heated rubber tends to soften—lowering the Shore A value—while cold rubber tends to harden, causing the Shore A reading to rise.
Selecting a scale that closely matches the measured signal helps an oscilloscope use its available ADC levels more effectively and reveal smaller voltage changes.
An oscilloscope can display less amplitude than the actual signal when its bandwidth is too close to the measured frequency. Understanding the -3 dB point, harmonic content, bandwidth limits, and rise time helps prevent misleading waveform measurements.
189 Testing the camshaft Hall sensor using the OWON VDS2064 oscilloscope enables technicians to capture, display, and analyze waveforms directly on a computer during automotive electrical diagnostics.
A practical overview of observing CAN Comfort signals in Volkswagen PASSAT B7 maintenance, including sleep-state readings and relevant OWON TAO3000 series features.
This practical overview explains how the OWON TAO3000 series and TAO3104A can be used to observe dual throttle position sensor signals during automotive testing.
Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D
Equipment restarts in a factory setting can be attributed to voltage sags, momentary power outages, electrical noise, overheating, or hardware faults. For incidents that last only a few power cycles, a power quality analyzer can capture voltage, current, and waveform data at the exact moment of the reset, thereby helping engineers determine whether the power supply is the cause
Record length is the number of data points stored during a single waveform acquisition. When the sampling rate remains constant, a longer record length allows the oscilloscope to capture the signal over a longer period of time. Record length affects the actual sampling rate, the ability to maintain a high sampling rate over an extended period, and the amount of data available for electrical waveform analysis.
OWON’s PC virtual oscilloscope is presented as a practical tool for observing crankshaft position sensor waveforms in automotive diagnostics, helping technicians analyze engine behavior more clearly.
인증된 전문가에게 직접 연결
