This presentation explores real-world measurement challenges commonly faced when using vector network analyzers (VNAs)

Explore the Latest Vector Network Analyzers and Real-world Measurement Use Cases

Content

This presentation explores real-world measurement challenges commonly faced when using vector network analyzers (VNAs), such as complex test setups requiring multiple instruments, underutilized equipment, and aging systems with limited vendor support. We introduce Keysight’s latest Streamline Series USB VNA—a compact solution that delivers performance comparable to traditional benchtop VNAs. Through a series of practical use cases, we’ll demonstrate how the Streamline Series VNA overcomes key test challenges across a range of applications, making it an ideal upgrade path for legacy and existing benchtop network analysis solutions.

Time

July 30 (Wednesday) at 10:00 a.m. SGT

Presenters

Takuya Hirato

Senior Product Manager Keysight Technologies

Taku Hirato is a product manager for Keysight Technologies' Communication Solution Group. He has 24 years’ experience in measurement applications for vector network analyzers. Taku started his career in R&D at Agilent Technologies in 2001, designing RF & microwave circuits. Since 2007, he has been an application development engineer and product manager for Keysight vector network analyzers. Taku received a Bachelor degree and Master’s degree of applied physics at Tohoku University, Japan in 1999 and 2001 respectively.

Get Rewarded by Inviting Your Friends/Colleagues

Win a free Find My Device Tracker by sharing with your friends/colleagues:

Copy your unique referral link from the registration confirmation page.

Share the link with your friends or colleagues.

Receive a “Find My Device Tracker” when they register and join the webinar.

관련 뉴스

2026년 08월 10일 14시 16분 08초

Comparing Shore A and Shore D Hardness: Two Common Hardness Scales Today

Both Shore A and Shore D are used to measure material hardness, but each scale is suited to a different group of materials. Soft rubber, silicone, or elastic gaskets are typically tested using Shore A, whereas hard plastics, engineering plastics, and materials with low deformation are better suited to Shore D

2026년 08월 10일 11시 17분 47초

What causes equipment to restart automatically in the factory, and how can the fault be identified?

Equipment restarts in a factory setting can be attributed to voltage sags, momentary power outages, electrical noise, overheating, or hardware faults. For incidents that last only a few power cycles, a power quality analyzer can capture voltage, current, and waveform data at the exact moment of the reset, thereby helping engineers determine whether the power supply is the cause

2026년 08월 10일 09시 29분 47초

Oscilloscope and Multimeter FAQ for Practical Test Workflows

This FAQ explains basic oscilloscope concepts, key selection factors, the purpose of Bluetooth multimeters, and the practical difference between OW18B and B35T+ models.

2026년 08월 10일 09시 28분 50초

Why Measured Amplitude Is Lower Than the Real Value

An oscilloscope can display a lower amplitude than the true signal when its bandwidth is not high enough. This article explains bandwidth, the 5x rule, and rise time in practical terms.

2026년 08월 10일 09시 27분 59초

Why Measured Amplitude Can Be Lower Than the Real Value

An oscilloscope can display a lower amplitude than expected when its bandwidth is too limited for the signal being measured. This article explains the relationship between bandwidth, rise time, and measurement accuracy.

Explore the Latest Vector Network Analysers and Real-world Measurement Use Cases