빠른 지원
인증된 전문가에게 직접 연결
인증된 전문가에게 직접 연결
Minimum system requirements: Refer to page 3 for requirements in using the Keysight IO Libraries
software (included with the instrument control hardware)
Supported standards:
– Supports USB 2.0 high speed
– Standard USB endpoints supported
– IEEE-488.1 and IEEE-488.2 compatible
– SICL and VISA 2.2
Unsupported GPIB modes of operation
– Pass Control
– Non-System Controller mode
General characteristics
Power USB: bus-powered device, +5 V, 500 mA (maximum), 200 mA (typical)
Maximum data rate (GPIB): 1.15 MB/s
Connectors
– Standard 24-pin IEEE-488 (GPIB)
– Standard USB A
USB hubs: Self-powered hubs
Parallel polling: A single parallel poll can easily check up to eight individual devices
at once, corresponding to the number of data lines on the GPIB
Cable: 2.5 meters, shielded, connector rated for 1,500 insertions
LED indicators: READY, ACCESS, FAIL
Maximum instrument connection: 14 instruments—daisy chain via GPIB. A maximum of 4 converters
can be connected to the PC.
Configuration: Plug-and-play
EMC and safety
– IEC 61010-1: 2001/EN 61010-1: 2001
– USA: UL61010-1: 2004
– Canada: CSA C22.2 No. 61010-1: 2004
Dimensions
Length, width, and height: 105 mm (L) x 64 mm (W) x 30 mm (H) (including connectors)
Weight: 215 grams
Environmental specifications
Operating environment: 0 °C to 55 °C
Operating humidity: Up to 90% at 40 °C non-condensing
Storage environment: –40 °C to 70 °C
Storage humidity: Up to 90% at 65 °C non-condensing
Ordering information
Accessories: GPIB cables/adapter
