빠른 지원
인증된 전문가에게 직접 연결
인증된 전문가에게 직접 연결
JUPITER+ allows :
- Identification of de-energized cables
- Identify phases in short-circuit mode and open circuit mode
- Continuity in short circuit mode and open circuit mode
- Low voltage and medium voltage de-energized cables and feeders identifier
- De-energized three phase cable identifier and phaser.
- Dead low or medium voltage cable identifier
USE PRINCIPLE
JUPITER+ consists of a transmitter and a Receiver, both can be used on the electric network, de-energized and earthed. The transmitter must be connected in a substation, on a MV cell or a LV feeder, using the 3 current clamps connected to each phase, excluding the outer sheath. The receiver allows cable pre-identifying, continuity checking and phase identifying in open circuit or short circuit modes.
TECHNICAL CHARACTERISTICS
TRANSMITTER
– Lead battery 12 V – 7.8 Ah
– Maximum autonomy : 10 h
– Can run on mains supply on 230 VAC
– 490 x 390 x 230 mm
– IP 62
RECEIVER
– 2 9 V PP3 batteries
– Maximum autonomy: 2000 measurements
– 380 x 290 x 70 mm
– IP 65
