NOTICE REGARDING THE HUNG VUONG ANCESTOR COMMEMORATION DAY HOLIDAY & APRIL 30TH - MAY 1ST HOLIDAY

While both are classified as soldering stations designed to melt solder, a technician repairing wiring inside an electrical cabinet and one working under a microscope on a mobile phone circuit board require vastly different types of equipment. Check out the article below!

The soldering station had just been unboxed, plugged in, and switched on for the first time. A few seconds later, a thin wisp of smoke rose from the tip, accompanied by a faint acrid smell. Before any soldering could even begin, many users hastily turned the unit off, fearing the equipment was damaged

The soldering iron is hot, yet even after touching the resistor lead for ten seconds or more, the solder just clumps up instead of flowing smoothly. A novice's first instinct is often to crank up the temperature. While that sometimes works, temperature isn't always the root cause; in many cases, increasing the heat only burns the flux and pads, potentially ruining the component leads in the process

Công ty CP EMIN Việt Nam thông báo lịch nghỉ lễ Quốc Khánh 2/9/2026

When thermal cameras are mentioned, most users immediately think of electrical cabinets, motors, PLCs, or HVAC systems in industrial facilities. However, the device's core principle observing surface temperature differences invisible to the naked eye can be applied in entirely unexpected places