NOVOTEST UT-3A-EMA 초음파 두께 측정기

Measuring thicknesses range for steel, mm: 2.0...60.0

Basic measurement accuracy, mm: 0.04

Permissible gap between device and testing object, mm: Up to 6

Permissible probe vertical deviation to the testing surface normal, grad: ±25

Notional sensitivity: Flat-bottomed hole in diameter of 9 mm

Minimal curvature radius of testing surface, mm: ≤10

Maximum measurements per second: 16

Setting range of the ultrasonic velocity, m / s: 1000-9999 with 1m/s step

Operating oscillation range, MHz: 3...5

Excitation wave type: Transverse wave, radial-polarized wave in surface plane of testing object

Time of continuous work hours, not less, h: 6

Overall dimensions, mm :232x135x44

Operating temperature range, ° C: -20 to +50

Standard set:

Electronic unit Ultrasonic Thickness Gauge

Transducer (probe) – 1 pc (depends on the desired range of controlled thickness)

2 AA batteries

Charger

Cables

Calibration certificate

Operating manual

Case

Available options:

Couplant; UT-probes; Calibration blocks

Description

NOVOTEST UT-3A-EMA is designed to measure thickness of objects, such as pipes, tanks, sheet products, ship bottoms and other parts, made of metals and alloys, without application of couplant and advance surface preparation, through air gap or a layer of rust, dirt, salt or other non-conductive coatings (paint, varnish, enamel, plastic, etc.) up to 6 mm. Also it is used for evaluation of anisotropy degree of the material. Pulsed electro - magnetic technology implemented in the EMA transducers allows user to put the probe not exact perpendiculary to the surface, but up to 25 degrees of skew and get correct readings.

Manual