빠른 지원
인증된 전문가에게 직접 연결
인증된 전문가에게 직접 연결
Wavelength:
- Minimum: 632 nm
- Typical: 642 nm
- Maximum: 652 nm
Full Output Power(b):
- Minimum: 15 mW
- Typical: 20 mW
Laser Power Stability (c):
- 15 min: ≤0.009 dB (≤0.2%)
- 24 hr: ≤0.009 dB (≤0.2%)
Internal Fiber: SM600
Output Fiber Connector: FC/PC, 2.2 mm Wide-Key Slot
(b)Specified at Temperature Set Point of 25 °C
(c)At 75% of maximum output power. The stability spec was obtained after a 1 hour warm-up period.
Display Accuracy (mW): ±5% of Actual
Laser Adjustment Range:
- Default Setting: Laser Threshold to Max
- Optional Setting: 0 mA Current to Max
Laser Adjustment Resolution: 0.01 mW (While Laser is Enabled)
Temperature Adjustment Range: 20°C to 30°C
Temperature Setpoint Resolution: 0.01°C
Modulation Input (a): 0 to 5 V (0 to Full Power)
Modulation Input Impedance: 1 kΩ
Modulation Input Connector(b): BNC
Modulation Bandwidth(c): ≤100 kHz, Sine Wave
General:
- Operating Temperature: 15 to 35°C
- Storage Temperature: 0 to 50°C
Input Power: 85 - 264 VAC, 50 - 60 Hz
USB Connector (b): Type B
(a) Modulation Input voltage directly corresponds to output power, where 5 V = Max Power and 0 V = 0 mW when the front panel knob is set to 0 mW. The maximum voltage will be less than 5 V when using the default laser adjustment range (Laser Threshold to Max).
(b) The maximum USB and BNC cable length is 3 meters in order to avoid a susceptibility to RF interference according to IEC61000-4-3.
(c) Waveforms other than sine waves contain components with higher frequency than the overall frequency of the waveform, which may not be followed.
