EXPO-RUSSIA VIETNAM 2017

EMIN supported SKB in EXPO-Russia Vietnam organized by the Vietnam Chamber of Commerce and Industry (VCCI) in cooperation with the Russian Federal Chamber of

EMIN supported SKB in EXPO-Russia Vietnam organized by the Vietnam Chamber of Commerce and Industry (VCCI) in cooperation with the Russian Federal Chamber of Commerce and Industry. The exhibition was held at the Melia Hotel Hanoi from 13 to 15/12/2017.

This is the second time, this event has been held in Vietnam to promote the development of the two countries,to strengthen trade and economic relations between Russia and Vietnam; To diversify forms of economic cooperation between Russia and Vietnam, to expand cooperation in the field of humanity and sociality as well as to promote export activities of enterprises and Russian organizations into Southeast Asia market.

Mr. Nguyen Tuan Hai, Deputy Director of International Relations Department (VCCI) highly appreciated the ideas and plans for exhibition of events organizers. With the participation of representatives from the Government, leaders of the Ministry of Industry and Trade and VCCI with hundreds of enterprises from both countries participated in the exhibition attract great interest of the community.

In the exhibition, we were glad to welcome Deputy Prime Minister Trinh Dinh Dung visited the booth.

Here are some photos of the show.

관련 뉴스

2026년 08월 06일 11시 04분 49초

Thước đo khe hở: Chọn đúng hệ đo

Căn lá hệ mét và hệ inch: Khác biệt nằm ở bản vẽ, không phải đơn vị đoCăn lá hệ mét và hệ inch: Khác biệt nằm ở bản vẽ, không phải đơn vị đo ## Thước đo khe

2026년 08월 06일 10시 34분 44초

6 early signs of a burnt start capacitor to avoid losing millions

"Silent capacitor burnout" refers to a phenomenon where a start capacitor gradually loses capacitance without exploding or emitting smoke, making it difficult for the user to detect the issue until the motor has sustained severe damage. The appliance continues to operate but runs sluggishly, overheats, and consumes twice the normal amount of electricity. Without periodic inspections, a component costing only a few tens of thousands of dong could force you to replace the entire motor, air conditioner compressor, or ceiling fan an expense running into the millions.

2026년 08월 05일 15시 30분 41초

Can an analog multimeter still measure capacitors?

An analog multimeter can still be used to quickly check if a capacitor is shorted, open-circuited, or capable of charging and discharging. However, if precise capacitance measurement or an assessment of capacitor quality is required, a digital multimeter or LCR meter will yield more reliable results

2026년 08월 05일 11시 19분 27초

Detect Motor Slip or Deceleration After Just a Few Minutes of RPM Measurement

By simply measuring the rotational speed (RPM) and comparing it against design specifications or historical maintenance data, engineers can detect signs of belt slippage, speed reduction, or power loss without needing to disassemble the motor

2026년 08월 04일 14시 45분 15초

Measuring Pump Shaft Speed? When Is It Necessary, and How Should It Be Done Correctly?

Measuring pump shaft speed helps determine the equipment's actual rotational speed (RPM), allowing for comparison against design specifications to detect issues such as belt slippage, incorrect gear ratios, abnormal motor operation, or failure to achieve the desired flow rate. Depending on operating conditions, engineers may choose a laser tachometer, a contact tachometer, or a stroboscope