Blog

The Faith FT8340 series is a multi-channel battery simulation solution used for testing everything from startup to sleep mode, verifying each state to detect faults.

Superconducting material testing requires controlled high-current output, accurate measurement, and responsive power delivery. This overview explains the test requirements and the stated capabilities of the FaithTech FTG power supply.

Testing solutions for e-bike batteries, BMS evaluation, power controllers, and abnormal operating scenarios.

Monitoring CO₂, fine particulate matter, and other relevant parameters with an air quality meter helps identify changes that may be difficult to detect through human senses alone.

CO2 is colorless and odorless but can accumulate in enclosed spaces. Use a CO2 gas detector to monitor air quality fluctuations and proactively ensure safety.

Elitech iCold is a cloud-based platform designed to support remote monitoring and management across temperature-sensitive cold chain operations.

The E04 error on a refrigerant pressure gauge may be related to abnormal pressure conditions. Electrostatic interference and moisture ingress are two possible causes mentioned in the relevant guidance. When the error appears, continuing to use the instrument may result in unreliable readings. Therefore, it is recommended to stop the measurement and troubleshoot the issue step by step.

A systematic troubleshooting guide for checking a refrigerant pressure gauge that does not respond during the vacuuming process, focusing on connections, reset procedures, and zero-point calibration.

A terminal lug inside an electrical cabinet may gradually heat up—a change almost imperceptible to the naked eye. A motor bearing begins to rise in temperature even before any abnormal noise occurs. These changes often manifest quite early, yet maintenance teams typically only begin investigating the cause once the equipment shuts down or a circuit breaker trips

A multimeter can measure currents in the microampere (µA) range, but the reading captures only a momentary value. When is a DMM sufficient, and when is a specialized current meter required?