Material  measuring: Aluminium, steel, stainless steel, cast iron, plexiglass, PVC, polystyrene and polyurethane.
Tough, impact, waterproof and dust resistant equivalent to IP54
Measurement Mode: Pulsed-Echo (P-E),  Echo-Echo ThruPaint™ (E-E) measurement Mode
Measurement Rate: 4Hz
Thickness Range: P-E: 0.63-500mm, E-E: 2.54 - 25.40mm
Measurement Accuracy: ±1% or ±0.1mm
Measurement Units: mm or inch
Selectable Reading Resolution: Lo; ie 0.1mm, 0.01 Inch, 10m/s, or 0.001 in/μs
Data Output: USB; to PC
Transducer Probe Type: Dual element
Battery Type: 2xAA
Battery Life: Alkaline: 15 hour, Lithium: 28 hour
Operating Temperature: -10 to 50°C
Size (w x h x d): 145x73x37mm 
Weight (including batteries): 210
Packing List: Elcometer MTG4, 5MHz 1/4 right angle transducer, couplant, wrist harness, screen protector, protective case, 2 x AA batteries, calibration certificate, operating instructions

Note: A transducer is not suppied with the Gause, must be ordered separately

Manual

Datasheet

Datasheet Transducer

MTG4 Material Thickness Gauge

With a choice of calibration options and measurement modes, the MTG4 is ideal for taking readings on a wide range of coated and uncoated materials.

As well as all the features of the MTG2, the MTG4 has two calibration options. Using an uncoated sample of test material of a known thickness, the gauge can be calibrated using 1-Point calibration. Alternatively, the user can select one of 39 pre-set materials stored within the gauge including; aluminium, steel, stainless steel, cast iron, plexiglass, PVC, polystyrene and polyurethane.

Measurement Mode

Echo-Echo ThruPaint™ (E-E) measurement mode enables readings to be taken on coated materials with a thickness range up to 25.4mm (1”).  In Echo-Echo ThruPaint™ mode, the coating thickness is ignored and the material thickness from the top surface of the material to the material density boundary is displayed.

Data Output

Compatible with ElcoMaster^® software, individual readings can be downloaded via USB to PC or similar device for further analysis.

Features: Pulsed-Echo (P-E) and Echo-Echo ThruPaint™ (E-E) measurement modes 1-Point, Material and Factory calibration options Pre-set measurement rate of 4 readings per second USB data output to PC or similar device

MTG4 Material Thickness Gauge

Technical Specification

STANDARDS:

ASTM E797, EN 14127, EN15317

¹ 5MHz 1/4" right angle transducer supplied

² Internet connection required

³ The Elcometer MTG range is extendable within 60 days from date of purchase, free of charge to two years

⁴ Dependent on the material being measured and the transducer being used

⁵ Whichever is the greater

⁶ Supplied with Alkaline, Lithium and rechargable can be used with the gauges, continuous use at 1 reading per second