快速支持
直接联系认证专家
Control mode: PLC control+touch screen interface
Test station: 1
Application: Adjusting luminaire (like drawing board
luminaires, shop-window spotlights, floodlighting luminaires)
Test driver: Servo motor
Twist angle: 0-3600 adjustable (standard requirement: 1250
in both directions from the vertical)
Test frequency: 1-10 times/min
Number of trials: 0-999,999 cycles presetable (a cycle of
operation is a movement from one extreme of the range to the other and back to
the starting position, to make sure the rate of movement can reach 600
cycles/h)
Specimen adjustment: The fixture is manually clamped and
adjusted up and down with AC motor, the maximum distance is 500mm
Maximum swing radius of the pendulum rod: R500mm, left and
right of the platform, front and rear adjustment strokes are 0-500mm
Specimen clamping method: pressure plate and adjustable
pressure block (three different fixtures can be distributed according to the
sample base provided by the customer)
Test procedure: The touch screen can display bending angle,
test cycles, number of trial
Alarm device: Flasher, auto stop
Dimension: 1300mm*750mm*1600mm (L*W*H)
Working power: 220V/50Hz
The bending test equipment for adjusting luminaire is designed to meet the test requirement of IEC60598-1 clause 4.14.3. The flexible cord or cable of adjusting luminaire shall have no more than 50% of the strands in a conductor be broken and no serious damage to the insulation after continuously bending and torsion.
