Máy đo độ ẩm vật liệu mỏng Finna T8 | EMIN.VN

Máy đo độ ẩm vật liệu mỏng Finna T8

Name: Máy đo độ ẩm vật liệu mỏng Finna T8
Brand: Finna

Có sẵn: 0 Cái

Hãng sản xuấtFinna

ModelT8

Xuất xứ.

Bảo hànhBảo hành: 12 tháng

Liên hệ

Số lượng

Thanh toán an toàn

Hỗ trợ chuyên nghiệp

Đổi trả dễ dàng

Giao hàng tận nơi

Ứng dụng : đo độ ẩm vật liệu mỏng, phẳng, cong, rắn hoặc nửa cứng.

Dãy đo : 0-35%

Thiết bị cầm tay, sử dụng pin sạc

Đo trực tiếp lên bề mặt

Phương pháp đo : tần số vô tuyến

Hiển thị : Analog

Nguồn điện sạc : 220VAC

Model T8: Thin Materials Moisture Meter

The Model T8 uses the Radio Frequency Capacitance Method to measure the moisture content of products. It operates from a single rechargeable NI-Cad battery. It gives the operator average moisture content down to a penetration of 1/8 to 1/4 of an inch. The electrode has three concentric rings that cover an area 3 inches in diameter. Complete with Rechargeable Battery, Carrying Case and Operating Instructions Book.

Product Description

Made for thin materials, the Model T8 thin materials moisture meter permits non-destructive tests for moisture content on most flat, curved, solid or semi-solid materials.
The T8 is ruggedly constructed, easy-to-use instrument with intergrated solid-state circuitry for reliability and long battery life. Its light weight design includes a molded handle with a spring-loaded switch bar that permits testing with either hand. Finna Group’s patented electrode designs project an RF field into the sample. The RF signal loss due to the presence of moisture is measured and displayed directly as “Moisture Content Percentage”.
The T8 is equipped with four sensitivity settings to provide moisture measurement in the range of 0-35% on most materials. The Zero Suppression feature provides scale overlap in all ranges from 0% to high moisture content. Built-in electrical standards for each range allows for calibration checks at any time by turning a switch, and a built-in adjustment trimmer for each range permits calibration to be reset if necessary. A battery regulator circuit provides constant calibration as the battery discharges.
Features
Designed for flat, smooth, thin materials such as single sheets or 1/8″ (3.2mm) stacks of veneer, cloth, paper or paperboard.
The specifically designed electrode of three concentric brass rings covers an area 3″ in diameter (7.6 mm).
Electrode Penetration: 1/8″ (3.2 mm).
Sample calibration curves available for a wide range of thin materials.

Additional Information

Process	Handheld
Pin Feature	Pinless
Contact Feature	Contact
Measurement Method	Radio Frequency
Reading Feature	Analog
Voltage	115 VAC, 220 VAC
CATALOG