Blog

Power electronics and power integrity aim to deliver suitable voltages, currents, and noise characteristics, yet differences in tools, vocabulary, and figures of merit can hinder alignment.

Clock jitter can interfere with digital circuits, including high-speed ADCs. High-speed clocks may be sensitive to power cleanliness, while quantifying that relationship takes careful effort.

A Rogowski coil produces a voltage related to the rate of change of enclosed current. Integration converts that signal to one proportional to current, but the method does not operate at DC.

Decree No. 08/2022/ND-CP (updated and amended by Decree No. 48/2026/ND-CP) sets strict regulations on emissions monitoring and administrative penalties for business, production, and service establishments.

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.

PDN measurement commonly relies on a vector network analyzer. The source distinguishes 1-port measurement for higher impedance from 2-port shunt-through measurement for very low impedance, while noting that instrument cost can affect the approach.