ニュース

As a Fluke distributor, EMIN provides a complete safety solution that helps plants proactively prevent incidents early on, rather than incurring costly remediation costs. Electrical discharges and gas leaks often silently persist for a long time before causing major incidents

Many water treatment systems, after a period of use, begin to show signs of RO membrane degradation faster than expected, stainless steel pipes becoming tarnished, or valve assemblies showing slight corrosion, even though the incoming water appears quite clean.

The difference between floor-standing and benchtop temperature test chambers goes far beyond physical size. More importantly, each chamber design creates a distinct thermal environment that affects the test specimen in completely different ways.

In the era of Smart Manufacturing and Digital Factories, managing and tracing product origins through barcodes (Barcode/Data Matrix) has become a rigorous standard.

When looking at the specifications of an electronic depth gauge, most people immediately notice the smallest division, the measuring range, or the water resistance. However, on the side of many models, there is an additional small port marked SPC

Some devices successfully complete full environmental test cycles, yet still develop corrosion, leakage current, or stability issues only a few months after being deployed in real-world conditions. In reliability testing and material durability evaluation, Temperature and Humidity Test Chamber systems are commonly used to simulate years of operation within just days or weeks. High temperature combined with elevated humidity accelerates aging processes, allowing engineers to observe failure mechanisms that would otherwise take a long time to appear under normal operating conditions.

When looking to buy a depth gauge, many people immediately look at the resolution because smaller numbers often give the impression of being more high-end. A display with 0.001 mm accuracy is quite appealing, especially with newer electronic models.

If you've observed electronics labs in recent years, you'll notice that the way they choose pulse generators has changed considerably. Previously, most attention was focused on specifications. The higher the MHz, the more waveforms, or the larger the display, the more likely the generator was to be preferred because it gave the impression of being durable and not becoming obsolete in the long run

A pulse generator might look very powerful in a catalog, but when you actually test it in a real circuit, quite a few annoying issues start to emerge. Some models produce a beautiful sine wave but have slight ripple at the edges of the pulse; some require many steps to change the waveform; and some models develop a loss of smoothness in the rotary knob or noticeably slow menu response after only a few months of use

Sometimes, a pulse signal may appear perfectly normal at first glance, but when viewed on an oscilloscope, it reveals slight vibrations, uneven amplitude, or timing deviations in cycles. The first reaction is usually to check the pulse generator, connections, or output load. However, many errors originate from the power supply section, especially the switching power supply