In the semiconductor testing and measurement sector—where every nanosecond and microvolt can determine the success or failure of a chip design—choosing the right test equipment has never been simply a matter of comparing specifications on paper.
A 100W soldering iron can deliver more heating power than a 40W model, but that does not necessarily mean it will solder faster in every situation. Soldering speed depends on the amount of heat that needs to be transferred to the workpiece and the tip's ability to maintain its temperature when it comes into contact with a thermal load.
Worn bearings do not cause an immediate drop in the engine's average speed. What changes first is speed stability slight fluctuations in speed occur from one rotation to the next even though a standard tachometer continues to display a seemingly normal RPM reading. This is precisely what many people overlook. While the average figure looks fine, detecting instantaneous fluctuations reveals that the bearings had actually begun to develop play quite some time earlier
High-voltage generators are used to produce controlled test voltages for evaluating the dielectric strength of insulation and electrical equipment. Depending on the voltage level, waveform, and test method, these devices can be used in laboratories, manufacturing plants, power substations, or for post-installation testing.
A DC resistance tester applies a controlled DC current and measures the resulting voltage to determine resistance. Proper wiring, discharge handling, and current selection support a stable measurement process.
Noise can reduce detection sensitivity or generate signals that may be mistaken for discharges occurring within the test specimen. This article examines common noise sources, noise coupling paths, and key considerations when evaluating partial discharge test results.
Chroma has integrated Rohde & Schwarz MXO oscilloscope hardware into its ATS 8000 automated test platform. The integration expands waveform measurement and analysis capabilities for testing power conversion devices, meeting the increasingly demanding requirements of high-power supplies and power systems used in data centers.
A practical guide to safer partial discharge detection system setup, focused on grounding, warm-up, interference reduction, calibration, and connection handling.
A switch parameter tester helps maintenance teams evaluate switching behavior in circuit breakers, isolating switches, and related switchgear. This guide explains its role, typical test workflow, data considerations, and selection factors.
A practical introduction to low-voltage phase testing, including its purpose, factors that influence readings, selection considerations, and essential safety practices.
인증된 전문가에게 직접 연결
